Point 1. Product composition

A PC mold with a diameter of 8 cm and a height of 8 cm (based on the finished candle).
A permanent plastic mold made of polycarbonate plastic that can be reused multiple times.
It takes approximately 250 grams of wax to make one candle.

Point 2. Neat spherical design

Smooth surface, cute size, can be combined with various candles, basic spherical design.
Because the mold construction is in two parts, the mold seam may show up as a thin line in the center of the finished candle.

Point 3. Homemade products

The Candleworks logo or word mark is engraved on the edge of the mold or near the wax core line.
This product is a mold directly designed and manufactured by Candleworks. Unauthorized copying is strictly prohibited and violators will be held legally responsible.

Point 4. Size comparison

You can check the dimensions by comparing them to similar shape types of spherical (round) and square candles based on the longest tapered mold.

PC large ball mold (8x8cm)

Size	Diameter 8cm x height 8cm
Texture	Polycarbonate plastic
Amount of wax required	About 250 grams
Maximum fragrance load	About 10%
Recommended wax core	No. 4 smokeless wax wick, No. 4 white cotton wax wick
Product Features	- Permanent plastic mold that can be reused multiple times. - Do not use a hot air blower when cleaning the mold or removing wax as this may cause the mold to warp. - The first time you use the mold, it is easy to release the wax from the mold using a release agent.

How to use PC mold

How to use column mold

Production 1. Insert the wax core and block the entrance with a mold sealer

After inserting the wax wick into the wax wick hole, use a mold sealer to cover the wax wick hole to prevent leakage of hot wax.

2. Spray release agent

Secure the wax core and spray release agent inside the mold. The release agent creates a thin lubricating film that helps the candle separate well from the mold.

Production 3. Melt wax

Melt wax according to mold size and capacity.

Production 4. Coloring

Use fat-soluble liquid dyes, color blocks, and pigment flakes to create the desired color for your application.

Preparation 5. Mix sesame oil

Although the temperature varies depending on the wax, add the sesame oil between 80-85 degrees and stir well for about 1 minute.

Production 6. Wax pouring

Based on the wax used for the column, pour the wax into the mold at a temperature of about 75~85℃.

Production 7. Fixed wax core

Using the wax wick clamp, gently pull on the wax wick and secure it in the center of the mold.

Production 8. Secondary wax pouring

When the surface of the wax hardens to a certain extent, use a glass rod to pierce the wax core around it, and pour the remaining wax into the blank space for the second time.

9. Remove the mold sealer

After the wax has completely hardened, remove the mold sealer before demoulding.

Production 10. Demold

After confirming that the mold has cooled, gently press the sides of the mold with your hands to create air gaps in the smaller shrinkage parts. Remove the candle from the mold and clean the wax wick.